Bench Vise Safety Tips

A bench vise, once in a while called the third hand, is an indispensable tool in the tool room or workshop. The bench Vises are usually mounted on workbenches or comparative firm backings to hold material set up.



What would it be a good idea for me to think about utilizing a vise?

The most bench vises can be used for a wide assortment of work. Select the most appropriate vise which is sufficiently solid for the work.

  • This is essential Wear safety glasses or goggles when utilizing striking tools or power tools on a workpiece held by a bench vise.
  • Attach a bench vise uses safely Place darts in all the gaps in the bench base of the vise. Use bolt washers under the nuts.
  • Mount a vise with the goal that the stationary jaw extends marginally past the edge of the workbench. This allows long work to was clamped in the vise without impedance from the edge of the workbench.
  • Ensure that the workbench has immovably secured to its base.
  • Check the bench vise for splits or other harm before clamping a workpiece in it.
  • Use a vise sufficiently expansive to hold the work without strain.
  • Place the workpiece in the vise with the goal that the full clamping surface of the jaw underpins the workpiece.
  • Keep the workpiece in the vise closed as conceivable to the jaws to counteract vibration while sawing, documenting, and so on.
  • Support the finish of additional long work with a movable stand; saw stallion, or box rather than putting additional strain on the vise.
  • Keep all strung and moving parts spotless, oiled and free of chips and earth.
  • Use jaw liners in a vise where there is any probability of denoting the work.
  • Replace a bowed handle, and worn jaw embeds.

What would you it be advisable for me not to do?

  • Do not weld the base of the bench vise to any metal.
  • Do not repair a bench vise by welding or brazing.
  • Do not endeavor to twist an overwhelming bar in a light bench vise.
  • Do not cut into the jaws.
  • Do not have any significant bearing overwhelming weight at the edge of the vise jaws.
  • Do not use a handle expansion (e.g., a pipe) for additional clamping weight.
  • Do not pound on the handle to fix past hand weight.
  • Do not use the jaws of the bench vise as an iron block.
  • Do not use any vise that has the smallest split.
  • Do not unscrew or open the jaws of the vise more extensive than they were intended to have used.


My Crafting Tools Copyright © by . All Rights Reserved.

Share This Book